MC9200 Controllers

There are many different combinations of basic controller and options available. The following summaries detail standard units and these will satisfy the vast majority of applications. However, a wide choice of upgrade kits is available for most of the Controllers. Therefore please contact us if you feel your requirement is not met by any of the units specified below or on pages detailing the other Series of Controllers.

9000 Series Controllers are supplied panel mounted with a certain amount of pre-wiring to assist with installation.

Multi Task Controllers for Single Cooling Towers

Click on the controller name to view a full specification sheet.

• MC9210AXXXBX; is a series 9200 PULSAtrol unit providing conductivity controlled system blowdown and inhibitor dosage via a selectable timer.
  
  
• MC9220AXXXBX; is a series 9200 PULSAtrol unit providing single point pH control.
  
  
• Click Manual to view an Operating & Installation Manual for the above controllers. A Quickstart Guide is also available.

MC9200 units are best suited for simple control requirements where conductivity controlled bleed or pH control is required.

Typically, select MC9200 units to dose an inhibitor via an impulse water meter, effect bleed via conductivity control (or adjust alkalinity via pH control and dose single or dual biocides via 28-day timers.

Click on Installation to view a guide highlighting key considerations for the installer.

9000 Series units can offer the PULSAworks communication facility.

Click Guide for full details and Manual to view the PULSAworks Manual.